| ordoprocinctus.com http://www.ordoprocinctus.com/forum/ |
|
| helmets http://www.ordoprocinctus.com/forum/viewtopic.php?f=2&t=63 |
Page 2 of 2 |
| Author: | Sir Eric [ Tue Jan 16, 2007 10:41 am ] |
| Post subject: | helmets |
Demonator, if I were you I'ld completely remake the visor of your helm to allow more space between it and your face and to cover below your chin. You definately don't want any sharp bits to contact your face when the visor is pushed forward, and ideally it wouldn't touch at all. |
|
| Author: | Sir Chris [ Tue Jan 16, 2007 3:12 pm ] |
| Post subject: | helmets |
sir eric, i been checking out your helmut and it appears that you have a damn good feild of vision in your helmet |
|
| Author: | Sir Eric [ Tue Jan 16, 2007 3:32 pm ] |
| Post subject: | helmets |
Quote: sir eric, i been checking out your helmut and it appears that you have a damn good feild of vision in your helmet Good vision at the cost of MUCH less protection. My ocular is way to big. It just so happens that you have to thrust downward from above to get inside of it. I would not recommend that anyone else leave that large of an ocular. |
|
| Author: | Sir Chris [ Tue Jan 16, 2007 3:39 pm ] |
| Post subject: | helmets |
how about if you put a middle bar and some strong mesh? |
|
| Author: | Sir Eric [ Tue Jan 16, 2007 3:46 pm ] |
| Post subject: | helmets |
Quote: how about if you put a middle bar and some strong mesh? If by "mesh" you mean perf plate, then that would do the trick. In fact, now that you mention it, I have a piece of perf that I've been meaning to add to my helm... |
|
| Author: | demonator [ Wed Jan 17, 2007 10:11 am ] |
| Post subject: | helmets |
thx Sir Eric,after last night figuring,and looking at some helms im going to take your advice and make a beefed up face guard,useing a piece metal i took off an old stove side.i will update soon. |
|
| Author: | elizabethann [ Wed Jan 31, 2007 3:58 pm ] |
| Post subject: | helmets |
where in covington did you purchase the helmet? |
|
| Author: | Sir Chris [ Thu Feb 01, 2007 12:15 pm ] |
| Post subject: | helmets |
Vincent's pawn on collins blvd across from Cordell furniture....don't know if they have any more ATM |
|
| Page 2 of 2 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|